View Single Post
  #1 (permalink)  
Old 03-27-2008, 03:42 PM
Fitzwilly's Avatar
Fitzwilly Fitzwilly is online now
COAI Regional Vice President Midwest
Donor Link Award A Thousand Thanks A Thousand Laughs 
 
Join Date: Dec 2004
Location: North Central Indiana
Posts: 5,335
Thanks: 819
Thanked 1,149 times in 729 posts
Laugh: 745
Got 1,031 laughs in 503 posts
Groans: 31
Groaned at 26 Times in 20 Posts
Default Intructions - Funky Dude Bracelet

From Custom Balloon Designs-Free balloon twisting,model,sculpture instructions



Cut a green 160 about 2/3 of the way down and tie a knot in the end. Blow up about an inch and a half. Squeeze equal amounts into each end and tie a knot in the middle. Tulip twist both ends.Take a full green 160. Blow up about two inches. Squeeze equal amounts into each end and tie a knot in the middle. Make a bubble then a pinch twist in each end to form feet.Cut up some brightly coloured 260's. Cut them roughly into threes and discard nozzles.Take another green 260 and blow up about two inches.
Hold the 'hair' in your hand so the ends are just behind the tips of your first finger and thumb.Rest your first finger on the knot of the 260 an push the hair into the balloon behind the nozzle. Grab the knot at the other side like a tulip twist.Wrap the 'legs' around the knot you have just grabbed.Push from the bottom about half-way into it. Careful, if you push too far the hair flies out the top. The twist will not be stable until you move unto the next stepTwist the head. This locks everything in place.Wrap the arms around the last twist and position in place.Draw a face on the little fellow. (As you may have noticed this isn't my strong point). The dude is place on the wrist the 260 goes around the wrist and is wrapped around the neck.
__________________
Dan/Fitzwilly
www.LaughingStockPro.com

Last edited by The_Princess_of_Bozonia; 04-27-2008 at 10:21 PM. Reason: added link
Reply With Quote
  The following 2 clowns say thank you to Fitzwilly for this great post: