In honor of all the safety clowns we have on the list.

Now onto a Fireman Hat.

(This will not be step by step photos as this is just my version of Ralph Dewey's Fireman Hat).


You will need:
2 - Red 260s
1 - Flames 5" Round

Start with a Red 260 blown up leaving a small tail, not even an inch and tie it. Make a 1" bubble and ear twist it, now wrap the balloon around the fireman's head and connect it to the ear twist. Make a 4 to 5" bubble and loop the rest of the 260 over the bubble making a 1" bubble in the tail of the balloon and connecting it there. Split that loop in half so you have this.


http://www.continentalsales.net/Education/MichaelPhilo/07Oct/photo5.jpg


Fully inflate the other red 260 and make it into a loop, tying the nozzle and end together. Twist off a third of it like so.


http://www.continentalsales.net/Education/MichaelPhilo/07Oct/photo6.jpg


Twist it onto the hat that you just made with the smaller part in the front and the bigger part in the back.


http://www.continentalsales.net/Education/MichaelPhilo/07Oct/photo7.jpg http://www.continentalsales.net/Education/MichaelPhilo/07Oct/photo8.jpg


Inflate the Flames 5" Yellow to about 4" and tie it high on the nozzle. Make a 1" pinch twist at the nozzle end and twist it into the top of the hat.


http://www.continentalsales.net/Education/MichaelPhilo/07Oct/photo9.jpg


A quick fire extinguisher can be made with a red 646.


Now to start the fire we need a BOMB !!!!!!!!!


It's just a fully inflated 11" Red round tied to a silver 260 inflated to about 12" with two 1" ear twists at each end and a 5" Flames tied to the other end.


http://www.continentalsales.net/Education/MichaelPhilo/07Oct/photo10.jpg


Have fun with it guys and have a great Halloween.

Michael Philo

CUTE! Much easier than the 5 balloon hat I found on another website!