Instructions - Honey Loving Bear (M. Philo)

[Fitzwilly]

Pooh

You will need:
1 Goldenrod 5" Round
1 Pooh Face Goldenrod Round
1 Goldenrod 260Q
1 Red 260Q
Inflate the 5" Pooh Face to 4" and tie it off, make a 1" ear twist and set the balloon aside.

Inflate the Goldenrod 5" Round to 4" and tie it off, make a 1" ear twist at the knot end and twist it together with the Pooh Face Balloon so you have this.

Inflate the Goldenrod 260Q to about 9" and tie it off, tie a knot in the other end as well. Cut off the nozzle and the end of the balloon close to the knots and split it in half. Twist this between the ear twist for his arms.

Inflate the leftover Goldenrod 260Q to about 9" and tie it off, tie a knot in the other end as well. Cut off the nozzle and the end of the balloon close to the knots and split it in half. Now make a 1" bubble at the bottom of the 5" Goldenrod and use the 260Q to secure it, twist the legs around the tail a lot to keep the tail from untwisting.

Inflate the Red 260Q leaving a 5 to6" tail and tie it in a loop. Divide this in half and in half again. Now roll one bubble around another to secure the 4 bubbles in place (bananna fold). Slide this over his head and push the arms through the sides (kind of like dressing a doll).